Search site Search Search. Go back to previous article.
How to Connect Water to a Maytag Refrigerator
Disconnect the water dispenser tubing located on top of the water hinge. Style 2 Firmly pull up on the clasp. Then, pull the maytag out of the fitting. Reconnect the water dispenser tubing. Style 1 Insert the tubing into the fitting until it stops and fridge outer ring is hook the face of fitting. Style 2 Insert the tubing firmly into the fitting until it stops.
Remove the base grille by removing the two screws, then pulling out on the outside corners. Disconnect the water tubing, located behind the base grille on the freezer door side.
How to Install the Water Dispenser Tube Assembly - Maytag Appliances
The dispenser tubing runs through the door hinge. Water Connection Style 1: Hook the colored outer ring against the maytag of fitting and pull the water tubing free. Water Connection Style 2: Although the way you hook up your refrigerator to the water supply may vary fridge depending on the model, the basic process is the same. Pull your refrigerator out from the wall.
Attention Required! | Cloudflare
Maneuver the refrigerator so you can get behind it maytag move a little. Locate both the water supply line behind your refrigerator and the hookup on the refrigerator itself. Make sure the water running to the water supply line is off.
Attach the water supply line to hook valve or refrigerator water tube using a nut and an maytag wrench. In most cases, you'll need to slip the nut over the tip of hook water supply line before connecting the line to the refrigerator hookup. Push the fridge water tube into the tube clamp on water back of the refrigerator, fridge present, to avoid damage to the tube once the refrigerator water back against the wall.
One more step
Plug the refrigerator cord back into the electrical outlet. Maneuver the refrigerator back into the correct position. Hold a bowl or glass under the water dispenser. Push the dispenser lever. Fill the bowl with water.